Grate Vents Inc
'Covering your needs since 1996'

PH: (815) 459-4306 
Email: gratevents@msn.com
732 Tek Drive, Suite C
Crystal Lake, Illinois 60014

Louvered Vents

  • Drop In - Floor Insert
  • Wall Mount - Cold Air Return
  • Framed Flush - Floor Insert
  • Tapered Base
  • Base Cold Air Return Grill

Drop-In Floor Vent:

Measure length and width of ductwork opening.   Standard widths: 2.25" , 4", and 6".   Standard Lengths: 8", 10", 12", and 14". Drop in may also be used for walls, ceilings, and toekicks. Lip is .75" - 1" around perimeter of grate.  18 standard wood species available.

Dampers available for Standard Sizes.  NOTE: Larger Sizes and Alternate Wood Species available upon request.

SHOP NOW

Framed Flush Floor Vent:

Measure length and width of ductwork opening.   

Standard widths: 2.25" , 4", and  6".   

Standard Lengths: 10", 12", and 14".  When installed, this model will set level with 3/4" wood flooring.  18 standard wood species available.

Dampers available for Standard Sizes.   NOTE: Larger Sizes and Alternate Wood Species available upon request.

SHOP NOW

Wall Mounted Cold Air Return:

Measure width (horizontal), and height (vertical) of opening in wall or ceiling. Lip on unit will extend approximately 1" beyond opening around perimeter of return.   18 Standard wood species available, and sizes from 10 wide x 6 high.

Note: Alternate Wood Species Available upon request.

SHOP NOW

Tapered Base Vent:

Width - Measure opening in baseboard, must be longer than the duct work opening.

Height - Measure the vertical opening up the wall, the vent must be higher than this measurement.  18 standard wood species available. 

NOTE: Larger Sizes and Alternate Wood Species available upon request.

Standard Widths: 15", 18", 24".

Height - Measure vertical distance up the wall, must be higher than duct work opening. Standard Height: 4-7/16.

Depth - Distance that the Grate extends onto floor from the wall.  Standard depth: 2-7/8". Dampers available for Standard Sizes. 

SHOP NOW

Base Cold Air Return Grille:

This model is used to replace the unsightly stamped metal returns commonly incorporated into the baseboard.  18 standard wood species available.

Width: Measure the opening in the baseboard, must be wider than the ductwork opening in the wall.   Standard Widths: 15", 18", 21" 24" and 32"

Height: Measure the vertical distance up the wall.  Must be higher than the ductwork opening.  Standard Heights: 7-1/4"  &  9-1/4"

Depth:  3/4"

Note:  Larger Sizes and Alternate Wood Species Available.

SHOP NOW

732 Tek Dr., Suite C
Crystal Lake, IL 60014

Phone: 815-459-4306
Email: gratevents@msn.com

Copyright©2017 All Rights Reserved.